Installation Procedure - Toto Guinevere TL970ddLq Manual De Instalación Y Del Propietario

insTaLLaTion procedure

1. spou� i���alla��o�
 insert spout through center hole�
 adjust the spout to face forward�
hold the spout in place� Tighten
lock nuts�
 Tighten lock nuts to secure spout�
 install the T-connector onto the
spout shank� do not over tighten�
2. valve body i���alla��o�
insert the valve body from underside

of the sink� make sure the Cold
side is on the right and the hoT side
is on the left�
place rubber gasket underneath the

deck adapter and screw deck adapter
onto the valve body until it bottoms
out� make sure rubber washer
lays flat in the groove of the deck
adapter�
position the valve body as shown

below then tighten the locknut�
screw in handle-adapter and push in

stem adapter from the top�
repeat procedure for the other

valve�
i���alla��o�
spout
gasket
washer
nut
rubber gasket
rubber
washer
Valve body position
(Bottom View)
4
lift rod
gasket
gasket
lock nut
o-ring
T-Connecctor
o-ring
stem adapter
handle adapter
deck adapter
rubber
Connector
washer
Brass
washer
Valve Body
lock nut