Use And Operation - oneConcept 10029735 Manual Del Usuario

1. When using the appliance, make sure that it is on a flat and stable surface. Damage may occur if
it is placed on an incline or decline, and put the ice box into water tank:
2. Insert the plug directly into a standard AC socket-outlet. Be sure plug fits tightly into outlet.
3. Press the SPEED button to set the desired fan speed (Low/ Medium/High).
4. VANE button: If you want to enlarge blast area in your room, press the vane button, the fan will
blast your room in large scope; the vane light will be illuminated. To stop vane, just press the
vane button again, the vane pilot light will go out. Moving the horizontal louvers either up or down
can make further wind direction enhancements.
5. TIMER button: Set the time by pressing the timer button to select a desired timing level as fol-
low, the range is between 0.5-9 hours. The pilot light corresponding to the selected timing level
will be illuminated.
6. MODE button: The default setting is Normal wind, and then you can press the button Mode again
to choose your desired wind mode as per the following sequence: The wind mode selecting can
be circulated and the wind mode pilot lamp will be on during the fan mode in operating.
7. COOL button: Please noted that the COOL LAMP will flashing when you press the Cool button if
there is no or lacked water in water tank.
8-1. Before operating the unit in Cool mode, make sure the escape valve for the water tank is
properly fixed. Then proceed to add clean water into the water tank. While adding the water,
make sure that you keep an eye on the water level indicator to make sure that you do not OVER
or UNDER FILL the unit. Press the button Cool after you have added the water and the unit should
commence to blow cooler air. The cool light will light on at the same time. When you press the
button Cool again, it will stop working, the cool light will also go out.
8-2. If you find that the air after Step 1) is still not cool enough, you can add additional ice block
into the water tank directly by opening the water tank cover. Be sure not to exceed the icebox
capacity otherwise damage to the unit or electric shock may occur.
8-3. If you wish to use an Ice box instead of ice block, just place it directly into the tank by open-
ing the water door. It will be good cooling efficiency if you place it in your refrigerator and let the

Use and Operation

9