Hergom H-01 Instrucciones Para La Instalación, Uso Y Mantenimiento página 23

The HEATER HEARTHS include a steel sheet pipe for A-37 "RC" quality
boilers
2.2 OPTIONAL ACCESSORIES FOR H-01
The following accessories may be adapted to this model:
x CAST IRON FRANKLIN-77 FRONT PIECE, to decorate the front of the
hearth. It is supplied painted in black or with a vitreous porcelain
enamel finish.
x THERMAL GLASS DOOR. Laminated steel with a large heat-resistant
glass piece for a full view of the fire. It is supplied with a special heat-
proof handle.
WARNING: Install the glass door before placing the cast iron front
piece.
x GRILL. Revolving grill, adjustable in height. Easy to install on its
anchor points on the side of the hearth (may also be adapted to H-02
and TC-1 models).
3.1 INSTALLING HEARTH H-01
1. Place the H-02 base on the floor.
2. Attach the back of H-06 over the back door of the base and fix using
the tabs by means of the two M-6x25 screws with washer and nut.
3. Fit the right hand side panel, H-04, in the groove on the base and in
the back panel. Attach it to the back tab using an M-6x25 screw with
washer and nut.
4. Perform the same operation with the left-hand side panel, H-05.
5. Fit the top back piece, H-07, (fit into the grooves) on the back and the
sides. Fix in place using the four M-6x35 screws with washers and
nuts.
6. Fit the frame around the sides of the hearth. Fix the top and bottom
in place by means of M-6x25 screws with washers and nuts.
7. Fit the right-hand side of the chimney, H-09, on the right-hand side of
the hearth and fix in place using an M-6x25 screw with washer and
nut.
8. Do the same with the left-hand side of the chimney (19), H-08.
9. Fit the bottom of the chimney, H-10, in the back top groove of the
hearth and fix it to the top tabs on the sides of the chimney using the
M-6x35 screws with washers and nuts.
3.- ASSEMBLY
- 23 -