Oven Door; Storage Drawer - GE 30 Serie Manual Del Propietário

Oven Door

The door is very heavy. Be careful when removing and lifting the door.
To remove the door:
1. Fully open the door.
2. Pull the hinge locks down toward the door frame, to
the unlocked position. A tool, such as a small flat-
blade screwdriver, may be required.
3. Firmly grasp both sides of the door at the top.
4. Close door to the door removal position. The door
should be open approximately 3" with no obstruction
above the door.
5. Lift door up and out until both hinge arms are clear of
the slots.
Slot
Hinge lock
Pull hinge locks down to unlock
Removable Storage Drawer
For Metal Rails (on some models)
The storage drawer is a good place to store cookware
material in the drawer.
The storage drawer may be removed for cleaning under
the range. Clean the storage drawer with a damp cloth or
sponge. Never use harsh abrasives or scouring pads.
Your storage drawer may have plastic slides or metal
rails. Follow the respective removal and replacement
instructions for your model's configuration.
Removing the Storage Drawer:
1. Pull drawer straight out until it
stops.
2. Continue to pull the drawer
until it is detached from the
oven.
Replacing the Storage Drawer:
1. Rest the left drawer rail around
the inner left rail guide and slide
it in slightly.
2. Place the right drawer rail
around the inner right rail guide
and slide it in slightly.
3. Slide the drawer all the way in.
22
Removal position
To replace the door:
1. Firmly grasp both sides of the door at the top.
2. Starting on the left side, with the door at the same
angle as the removal position, seat the indentation of
the hinge arm into the bottom edge of the hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for right side.
3. Fully open the door. If the door will not fully open, the
indentation is not seated correctly in the bottom edge
of the slot.
4. Push the hinge locks up against the front frame of the
oven cavity, to the locked position.
5. Close the oven door.
Hinge
arm
Hinge
lock
Push hinge locks up to lock
For Plastic Slides (on some models)
To remove the drawer:
1. Pull the drawer out until it stops.
2. Lift the front of the drawer until the stops clear the
guides.
3. Remove the drawer.
To replace the drawer:
1. Place the drawer rails on the guides.
2. Push the drawer back until it stops.
3. Lift the front of the drawer and push back until the
stops clear the guides.
4. Lower the front of the drawer and push back until it
closes.
Hinge arm
Bottom
edge of
slot
Indentation
Rail
Stop guide
49-80815