Grundig Globe Traveler G3 El Manual Del Propietario página 10

SETTING ALARMS 1 THROUGH 4 continued
6. While they appear in the display use the tuning knob to set the
wake-up alarm's play minutes from 1-99, then press the PAGE/TIME
button, causing the memory page number to appear in the display.
7. While it's in the display use the tuning knob to set the memory page
number or select no page number by selecting 00 if you want to use
the last frequency that you were tuned to.
8. Skip this step if you want to use the last frequency tuned to wake
to. While the page number is in the display press one of the F1-7
buttons to select the memory location on the selected page of the
frequency you want to wake to (the square flashes).
9. Press the PAGE/TIME button to finish the set-up.
ACTIVATING AND DEACTIVATING THE ALARMS
For an alarm to turn the radio on, it must be activated. To activate the
alarm to be used, turn off the G3 and press the appropriate alarm
button, F1-4. This causes the timer activation symbol to appear in the
upper left corner of the display, activating the selected alarm. To deac-
tivate the alarm, press the appropriate F1-4 button, causing the alarm
activation symbol to disappear.
USING THE LIGHT
The light illuminates the display and buttons. Turn it on and off by
pressing the LIGHT button. When using batteries the light stays on for
about 6 seconds; when using an AC adapter it stays on indefinitely or
until turned off.
EXTERNAL ANTENNA SOCKET
The external antenna socket is used to connect the G3 to advanced
performance shortwave antennas using a 50 or 75-Ohm coaxial cable
feed-line.
18
GLOBE TRAVELER G3 OWNER'S MANUAL
FM STEREO/MONO SELECTION
When listening to FM stations, stereo/mono is selected automatically
depending on the quality of the audio from the station.
LINE-IN/OUT SOCKET
This socket provides an industry standard, fixed level audio input/output
source for safely routing the G3's audio to the line-in socket of a stereo
system or recording device, or playing an audio device, such as MP3,
through the G3.
To route a line-in source into the G3, turn it off, attach a double 1/8
inch (3.5mm) stereo cord to the G3's LINE –IN/OUT socket and to the
output of the other system. Press the G3's LINE-IN button, labeled
TZ/LINE-IN.
To route the audio output of your G3 to another device, turn it on, plug
a 1/8 inch (3.5mm) stereo cord into the G3's LINE-IN/OUT socket and
into the other device's LINE-IN socket. Follow your external device's line-
input/output instructions.
EARPHONE SOCKET AND USING EARPHONES
(not included)
Plug them into the earphone socket on the left side of the radio.
Turn the volume down before wearing the earphones, then turn up
the volume to your liking.
REAR FOLDING STAND
Pull the folding stand from the rear of the G3, allowing viewing at a
comfortable angle.
GLOBE TRAVELER G3 OWNER'S MANUAL
19