Toto TLK03001G Manual De Instalación Y Del Propietario página 13

INSTALLATION PROCEDURE - Sub Tank Unit
1. Connect the hose to the sub-tank.
* Use the connection hose for connecting
the tank and cut to the desired length to fit
between the sub-tank and the tank.
Caution
 Do not have kinks or excessive bends in the
hose.
 Check that all cap nuts are tight.
If loose, liquid leaks.
Check them periodically.
2. Connect one end of the connection hose to
the coupling cap on the side of the tank.
Caution
Be sure to tighten the hose connection with the
hose clamp to secure it into place.
3. Connect the air deflation hose.
Caution
Be sure to tighten the air deflation hose
securely with the hose clamp.
4. Attach the elbow to the front end of the air
deflation hose and attach it to the wall with
the hose tie and wood screw.
* Do not block the elbow. It is the air bleed
point for the system. The soap will not
flow properly if the elbow is blocked.
 Be sure to install the elbow between the
top of the sub-tank and the counter.
When the elbow is installed lower than
the sub tank the soap overflows.
 Be sure that the hose tie is in position with
the air deflation hose and the elbow.
Check
Connection hose
Air deflation hose
Check
Elbow
Air deflation hose
13
Hose clamp
Connection
hose
Sub-tank
Hose clamp
Hose clamp
Hose tie
Wood Screw
Tank
Air