Toto TLK03001G Manual De Instalación Y Del Propietario página 6

1. Insert the dispenser into the installation
holes in the counter (or the sink).
2. Disassemble screw and washer with the
hex nuts.
Caution
Make sure that the cords and tubes do not get
crimped.
INSTALLATION PROCEDURE - Controller
Marking of the positions of the screw holes for the anchoring plate.
Decide the anchoring position of the controller and mark the positions of screw holes on the wall by
referring to the dimensional drawing.
[ 3L Tank Type ]
Reference
anchoring screw
3 . 7
Installing the controller on a tiled or concrete wall
1. Drill a rough hole at the screw hole position
and drive in the curl plug (procure in the field).
* Procure a curl plug that matches the screw
(Φ 5.1 x 32).
2. Anchor the bottom anchoring plate to the
controller with one countersunk tapping screw.
Caution
 Do not tighten the screws with an electric
screwdriver.
These should be tightened manually.
 Pay attention not to confuse the top side and
the bottom side of the anchoring plate.
INSTALLATION PROCEDURE - Spout
' '
5 . 9
' '
1 . 9
' '
Dispenser
Packing
Sensor cord
[ 1L Tank Type ]
0 . 8
' '
2 . 8
5 . 4
' '
Reference
anchoring screw
Anchor
Controller (Back side)
Anchoring plate
Anchoring plate
Countersunk tapping screw
(Φ 4 x 10)
6
Washer
Hex nut
Air hose (blue)
Liquid soap hose
(clear)
(Unit: Inch)
' '
3 . 7
' '
5 . 9
' '
1 . 9
' '
Countersunk
tapping screw
(Φ 4 x 10)
Top side Bottom side