Storing Stations Into Memory - Grundig G6 AVIATOR Guía De Funcionadmiento

TUNING SSB (SINGLE SIDEBAND) continued
Turn on the G6. Tune to the shortwave frequency of your choice,
using the methods described. To use SSB, turn on the SSB circuit
by pressing the SSB button. Note that SSB appears in the display.
Use the tuning knob to FAST-tune the SSB signal, then SLOW-tune
with the tuning knob. Press the JOG button to change from 'Fast'
to 'Slow' tuning. The SSB circuit allows tuning of both upper and
lower sideband signals.

STORING STATIONS INTO MEMORY

The G6 has 700 memories (also called presets), arranged in 100
pages (page 00-99), with each page holding 7 memories. Buttons
#1-7 represent memory locations. All memories are randomly pro-
grammable, meaning that any kind of frequency can be stored into
any memory. SSB selection is not stored.
Note that when storing into an already occupied memory position,
its contents will be replaced with your new entry.
1. Turn on the G6.
2. Tune to the desired station.
3. Press the PAGE/TIME button to place the G6 into MEMO mode.
4. To select the desired memory page (00-99) use the AUTO
buttons.
5. Store the station by pressing one of the #1-7 buttons for about
2 seconds or until the square around the memory location in the
LCD blinks.
6. To store another station, get out of memo mode by pressing
PAGE/TIME and tune to the station; then repeat the steps above.
7. When finished storing stations, press the PAGE/TIME button to
exit MEMO mode.
G6 AVIATOR OWNER'S MANUAL
11