Manual Tuning; Direct Frequency Entry - Grundig G6 AVIATOR Guía De Funcionadmiento

MANUAL TUNING

Quick, short, sequential presses of the AUTO
tuning up or down frequency. Alternately, the TUNING knob can be
used.
In Shortwave the tuning knob or manual tuning must be used to
tune out of the broadcast bands.

DIRECT FREQUENCY ENTRY

Turn on the G6. Use this method when the desired frequency of a
radio station is known. AM, LW and SW frequencies are entered in
kilohertz (KHz), e.g. 810 KHz, 162 KHz or 9475 KHz.; FM and Air
Band frequencies are entered in megahertz (MHz), e.g. 102.9 MHz
or 124.870 MHz, ignoring the decimal point.
1. Use the numeric keypad buttons to enter the frequency.
2. Within 3 seconds, press the AM button if it's an MW (AM), LW,
SW or AIR frequency, or the FM button for FM frequencies.
AUTO-SEARCH TUNING
With the G6 on, auto-search tuning starts by pressing either of the
AUTO SEARCH buttons (AUTO
has 3 selectable auto-search modes: STOP, ATS or D-5. The factory
programmed default mode is STOP. These are described below.
STOP: Auto-searching stops on the next encountered station.
D-: Auto-searching stops for 5 seconds on each encountered sta-
tion, then moves on.
ATS: (Auto Tuning Storage): Auto-searching automatically stores the
strongest FM local stations into memories starting with page
99 and counting downward until all are stored, e.g. 98, 97,
96, etc. Tune to the FM band and perform auto-search.
8
G6 AVIATOR
buttons enables
) for about 2 seconds. The G6
OWNER'S MANUAL