Assembly & Operation - Worx WG719 Manual De Instrucciones

ASSEMBLY & OPERATION
ACTION
ASSEMBLE
Assembling the handle bar
Adjustment Handle's height
Assembling the grass
collection bag
Assembling the grass
collection bag to the lawn
mower
Removing/emptying the
grass collection bag
Installing side-discharge
chute
Installing mulching plug
OPERATION
Starting
Stopping
Adjusting The Cutting Height
14
NOTE: Pull the Cutting
Height Adjustment Lever
(8) to adjust the rear of the
mower height only. Pull the
Front Caster Wheel Height
Adjustment Lever (6) to
adjust the Front Wheel Height
in the same time to adjust the
same cutting height.
Lock/Unlock Front Caster
Wheel
NOTE: When the mower
climb slopes, the Front Caster
Wheel Control Button should
be locked to keep straight.
But in the smooth garden, the
Front Caster Wheel Control
Button should be unlocked to
keep maneuverability.
STORAGE
13AMP Electric Lawn Mower
MULCHING MOWING TIPS
While mulching, your new mower is designed
FIGURE
to cut the grass clippings into small pieces
and distribute them back into the lawn. Under
normal conditions, the mulched grasses will
See Fig. A1
biodegrade quickly to provide nutrients to the
lawn.
See Fig. A2
Please review the following recommendations
for optimum mulching performance.
See Fig. B
1. Avoid mowing when the grass is wet from
See Fig. C1
C2 C3
See Fig. C4
2. For best mulching performance, set
See Fig. D1 D2
See Fig. E1 E2
See Fig. F1 F2
See Fig. F3
3. For best performance, keep the mower
See Fig. G
4. Certain types of grass or grass conditions
See Fig. H1 H2
5. Change your cutting pattern from week to
See Fig. I1 I2
rain or dew. Wet grass may form clumps
which interfere with the mulching action
and reduce runtime. The best time to mow
grass is in the late afternoon when the
grass is dry and the newly cut area will not
be exposed to direct sunlight.
the cutting height to remove about one
third of the grass blade length, ideally
no more than 1-1/2" at one time. If the
lawn is overgrown, it may be necessary
to increase the cut height to reduce the
pushing effort and prevent overloading the
motor. For extremely heavy mulching, it is
advisable to first cut at a high cut height
setting, and then re-cut to the final cut
height. Otherwise, make narrower cuts and
mow slowly.
housing free of built-up grass. From time
to time turn off mower and wait for the
blade to come to a complete stop. Using
an object such as a stick, wipe out any
accumulation of grass in the blade area.
Be careful of the sharp edges of the blade.
Clean often in wet, new grass, and always
after every use.
may require that an area be mulched a
second time to fully disperse the grass
throughout the lawn. If cutting a second
time, it is advisable to cut perpendicular
(across) the first cut pattern. DO NOT
CHANGE CUT PATTERN IN ANY WAY THAT
WOULD CAUSE MOWING DOWN A HILL.
week. This will help prevent matting and
graining of the lawn.
CAUTION: Do not attempt to unclog
the blade chamber by dropping or
EN