Assembling Your Chipper Shredder Vacuum - MTD 24A-020D000 Manual De Instrucciones

WARNING - YOUR RESPONSIBILITY:
understand and follow the warnings and instructions in this manual and on the machine.
NOTE: Not all safety labels shown may apply to your chipper shredder vacuum.
SECTION 2: ASSEMBLING YOUR CHIPPER SHREDDER VACUUM
This unit is shipped without gasoline or oil
IMPORTANT:
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: Reference to right or left hand side of the
chipper shredder vacuum is observed from the
operating position.
Removing Unit From Carton
• Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
• Remove loose parts if included with unit (i.e.,
operator's manual, etc.)
• Cut along corners, lay carton down flat, and remove
packing material.
• Roll or slide unit out of carton and check carton
thoroughly for loose parts.
Loose Parts In Carton
• Handle Assembly
• Bag
• Blower Chute (If Equipped)
Disconnecting Spark Plug Wire
Before setting up your chipper shredder vacuum,
disconnect the spark plug wire from the spark plug and
ground to a stud on the engine.
(See Figure 1)
Restrict the use of this power machine to persons who read,
Blower Chute
Wing
Nuts
Lower
Handle
Wing
Nuts
Carriage
Screw
5
Upper
Handle
Figure 1
Bag