Publicidad
Idiomas disponibles
Idiomas disponibles
Warnings
Failure to observe recommendations included in this manual may cause risk to
life and health or result in malfunction of the device.
The manufacturer, Fibar Group S.A. will not be held responsible for any loss or
damage resulting from not following instructions of the manuals.
Risk of malfunction as a result of tampering with the device.
The device should be installed below the ceiling level.
The device should not be installed: in a bathroom, next to heat sources, within
range of kids, obstructed from possible carbon monoxide sources, in direct sunlight.
The device is not a substitute for appropriate ventilation and exhaust systems.
Do not paint the device.
The device should be cleaned with a slightly damp cloth or moistened tissue.
Replace the device before date on the front or if sensor error is detected.
Place of installation (page 4)
Install the device on the wall, at least 30 cm (1 ft) away from the corner.
Recommended height of installation is dependant on the purpose of the room
and height at which head typically is.
Installation (page 6/7)
1. Turn the cover counter clockwise (Fig. 1).
2. Take off the cover (Fig. 2).
3. Remove the paper strip protecting the battery (Fig. 3).
4. Proper powering up will be confirmed with a short beep (Fig. 4).
5. Mount the cover on a wall (Fig. 5).
6. Attach the device to its cover (Fig. 6).
7. Turn the device clockwise to close it (Fig. 7).
10
Publicidad
