Auxiliary Handle - SPIT 332 Manual Original

16 | English
Assembly
B efore any work on the machine itself, pull the
 
mains plug .

Auxiliary Handle

Operate your machine only with the auxiliary

handle 12 .
Changing the position of the auxiliary
handle (see figure A)
The auxiliary handle 12 can be set to any position for
a secure and low-fatigue working posture .
– Turn the bottom part of the auxiliary handle 12 in
counterclockwise direction and swivel the auxiliary
handle 12 to the desired position . Then retighten the
bottom part of the auxiliary handle 12 by turning in
clockwise direction .
– Pay attention that the clamping band of the auxiliary
handle is positioned in the groove on the housing
as intended for .
Adjusting the Drilling Depth (see figure B)
The required drilling depth X can be set with the depth
stop 11 .
– Press the button for the depth stop adjustment 10
and insert the depth stop into the auxiliary handle
12 . The knurled surface of the depth stop 11 must
face downward .
– Insert the SDS-plus drilling tool to the stop into the
SDSplus tool holder 3 . Otherwise, the movability
of the SDSplus drilling tool can lead to incorrect
adjustment of the drilling depth .
– Pull out the depth stop until the distance between
the tip of the drill bit and the tip of the depth stop
correspond with the desired drilling depth X .
Selecting Drill Chucks and Tools
Material
Concrete Ø 4–28 mm
SDS-plus
Brickwork Ø 40–82
mm
SDS-plus
Steel
––
Operating Mode
SDS-plus
––
SDS-plus
––
Ø –13 mm
SDS-plus
Material
Steel
––
Wood
––
For hammer drilling and chiselling, SDS-plus tools are
required that are inserted in the SDS-plus drill chuck .
For drilling without impact in wood, metal, ceramic
and plastic as well as for screwdriving, tools without
SDS-plus are used (e .g ., drills with cylindrical shank) .
For these tools, a keyless chuck or a key type drill
chuck are required .
The SDS-plus quick change chuck 2 can easily be
replaced against the quick change keyless chuck 1 .
Removing the Quick Change Chuck
(see figure C)
– Pull the lock ring for the quick change chuck 6 toward
the rear, hold it in this position and pull off the SDS-
plus quick change chuck 2 or the quick change
keyless chuck 1 toward the front .
– After removing, protect the replacement chuck
against contamination .
Inserting the Quick Change Chuck (see figure D)
Use only model-specific original equipment and

pay attention to the number of identification
grooves 16. Only quick-change chucks with two
or three identification grooves are permitted.
When an unsuitable quick-change chuck is used,
the application tool could fall out during operation .
– Before inserting, clean the quick change chuck and
apply a light coat of grease to the shank end .
– Grasp the SDS-plus quick change chuck 2 or the
quick change keyless chuck 1 completely with your
hand . Slide the quick change chuck with a turning
motion onto the drill chuck mounting 15 until a distinct
latching noise is heard .
– The quick change chuck is automatically locked .
Check the locking effect by pulling the quick change
chuck .
Operating Mode
Ø –13 mm
SDS-plus
Ø –30 mm
SDS-plus