Publicidad
Idiomas disponibles
Idiomas disponibles
18 | English
Setting the Speed/Impact Rate
The speed/impact rate of the switched on power tool
can be variably adjusted, depending on how far the
On/Off switch 7 is pressed .
Light pressure on the On/Off switch 7 results in low
speed/impact rate . Further pressure on the switch
increases the speed/impact rate .
Safety Clutch
I f the tool insert becomes caught or jammed, the
drive to the drill spindle is interrupted. Because
of the forces that occur, always hold the power
tool firmly with both hands and provide for a
secure stance .
I f the power tool jams, switch the machine off
and loosen the tool insert. When switching the
machine on with the drilling tool jammed, high
reaction torques can occur.
Working Advice
Before any work on the machine itself, pull the
mains plug.
Changing the Chiselling Position
(Vario-Lock)
The chisel can be locked in 36 positions . In this man-
ner, the optimum working position can be set for each
application .
– Insert the chisel into the tool holder .
– Turn the mode selector switch 9 to the "Vario-Lock"
position (see "Setting the Operating Mode", page 17) .
– Turn the tool holder to the desired chiselling position .
– Turn the mode selector switch 9 to the "chiselling"
position . The tool holder is now locked .
– For chiselling, set the rotation direction to right
rotation .
Inserting Screwdriver Bits (see figure I)
Apply the power tool to the screw/nut only when
it is switched off . Rotating tool inserts can slip off .
To work with screwdriver bits, a universal bit holder 19
with SDS-plus shank (accessory) is required .
– Clean the shank end of the adapter shank and apply
a light coat of grease .
– Insert the universal bit holder with a turning motion
into the tool holder until it automatically locks .
– Check the locking effect by pulling the universal
bit holder .
– Insert a screwdriver bit into the universal bit holder .
Use only screwdriver bits that match the screw head .
– Turn the mode selector switch 9 to the "drilling"
position .
– To remove the universal bit holder, pull the locking
sleeve 5 toward the rear and remove the universal
bit holder 19 out of the tool holder .
Maintenance and Service
Maintenance and Cleaning
B efore any work on the machine itself, pull the
mains plug.
F or safe and proper working, always keep the
machine and ventilation slots clean.
A damaged dust protection cap should be chan-
ged immediately. We recommend having this
carried out by an after-sales service .
– Clean the tool holder 3 each time after using .
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
Spit power tools .
After-sales Service
and Customer Assistance
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts . Exploded views and information
on spare parts can also be found under:
www.spit.com
Our customer service representatives can answer
your questions concerning possible applications and
adjustment of products and accessories .
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling .
Do not dispose of power tools into household waste!
Only for EC countries:
According the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
tools that are no longer usable must
be collected separately and disposed
of in an environmentally correct man-
ner .
Subject to change without notice.
Publicidad
