General; Installation; Unpacking - Hobart centerline EDGE13A ML-136348 Manual De Instrucciones

Installation, Operation and Care of
CENTERLINE BY HOBART AUTOMATIC SLICER
The Centerline by Hobart Automatic slicer is equipped with a
forged carbon steel. The Slicer Base, Product Tray, Knife Cover, Ring Guard, and Gauge Plate are made
of smooth finish anodized cast aluminum for easy cleaning. The rear-mounted Meat Grip is hinged on a
rod with extension behind the Product Tray. The top-mounted knife Sharpener is removable for cleaning.
A cord and plug is furnished as standard equipment.
The slicer must be thoroughly cleaned, rinsed and sanitized after installation and before being used. Refer
to CLEANING on page 5.

UNPACKING

The slicer was inspected before leaving the factory. The carrier assumes full responsibility for safe delivery
upon acceptance of the shipment. Check for possible shipping damage immediately after receipt.
If the slicer is found to be damaged, complete the following steps:
1. Carrier must be notified within five business days of receipt.
2. Carrier's local terminal must be notified immediately upon discovery (note the time, date, and who
was spoken to), and follow up and confirm with written or electronic communication.
3. All original packing materials must be kept for inspection purposes.
4. The slicer cannot have been moved, installed,
or modified.
5. Notify Hobart customer care at (800) 333-7447.
Prior to installing the slicer, test the electrical service
to make sure that it agrees with the specifications on
the machine data plate. The data plate is located on
the right side of the slicer base.
The Product Tray is secured to the slicer by turning
the Knob (Fig. 2) below the Product Tray clockwise
until snug.
Mount the Sharpener on top of the slicer (Fig. 1)
by lowering it onto its post. The Sharpener can be
removed for cleaning.
The Slice Deflector (Fig. 1) should already be mounted
below the knife.
SAVE THESE INSTRUCTIONS

GENERAL

INSTALLATION

– 3 –
/ Hp. motor. The slicer Knife is chrome-plated
1
2
SHARPENER (R)
KNIFE
COVER
KNOB (R)
PRODUCT
TRAY (R)
CARRIAGE
HANDLE
SLICE DEFLECTOR (R)
(R) refers to removable part.
Fig. 1