Resetting Pressure Sensors; Factory Settings; Resetting The External Vacuum Sensor - Refco DIGIMON-SE Guía De Instalación Y Funcionamiento

English

Resetting pressure sensors

By pressing the
reset to zero, in order to avoid incorrect measurement values.
To obtain a correct measurement value on the display, the DIGIMON
should not be reset when pressurised or under a vacuum.

Factory settings


Set the DIGIMON to the "Digital display" screen.

Press the
 Display shows - - - - - - - -

Press the

Resetting the external vacuum sensor


Switch off the DIGIMON

Connect vacuum sensor

Hold down the
button.
 Display shows VAC-ZERO

Press the

The device can be switched on using the
operation once again.
16
SET LIGHT
and
LIGHT VAC
and
SET
button to exit.
VAC
button and switch on the device using the
SET
button to exit
Instruction Manual DIGIMON-SE / DIGIMON4
buttons the DIGIMON pressure displays are
buttons at the same time for 5 seconds.
display shows End.
ON/OFF
button and is ready for
ON/OFF