Equipment Operation - GNATUS Optilight Color Manual Del Proprietário

EQUIPMENT OPERATION

Press
- Press the button to turn on the equipment (fig.1).
- Select the application mode pressing the selection button (fig.2), which variations are:
- Continuous: Maximum mode and continuous for light intensity (same luminosity from
the beginning to the end of the polymerization).
- Ramp: Gradual mode, light intensity increases gradually.
- Pulse: Pulse modes are cycles that oscillate at a fixed frequency.
• The chosen application mode shall be seen in the LEDs' sequence.
• For setting time, press the button and chose a time between a time from 5 to 20
seconds, which will be seen on the display (fig.3).
10mm
-After selecting the application mode
and the choice of time, remove the
light conductor protection cover
and take the handpiece to the
patient's mouth and position the light
conductor at a safe distance (fig.4).
ATTENTION:
Low battery warning:
- When the display shows the symbology
battery, please recharge it.
- The LED charge's indicator (A) gets red when the battery is charging and green when
the charging is complete.
- Always keep the handpiece over the base, getting energized, when not using it;
- The approximate time for the recharge is 4 hours. After the recharge, the LED's
charge indicator (A) will change for green, indicating the complete recharge;
- The battery does not have a memory effect and can be recharged, even if it's not
completely discharged.
Fig.1
Fig.4
Press
Fig.2
Fig.5
and sound the beep indicating low
38
Press
- F o r s t a r t i n g
polymerization cycle, press
the trigger. Just trigger
again to interrupt (fig.5).
Carga
A
Fig.3
t h e