Metra INST-6000 Instrucciones De Instalación página 15

Dodge D-50 pick-up 1987-1993
Mitsubishi Mighty Max 1987-1996
1. Remove (2) screws located
under the A/C vents. Remove the
climate control knobs.
2. Remove (2) screws above the
climate controls.
3. Using a small screwdriver, unclip
the top of the dash trim bezel
and remove the bezel.
4. Remove (4) Phillips screws
securing the factory radio and
(Figure A)
Dash Disassembly 99-7000
disconnect the wiring. (Figure A)
5. Snap the filler bar onto the
equalizer housing and slide the
assembly onto the bottom of the
radio housing. (Figure B)
Note: The factory pocket may be
used by omitting this step and
mounting the pocket under the
radio housing during installation.
6. Cut and remove all mounting
(Figure B)
tabs on bracket Set #1 EXCEPT
tabs "F". (Figure C)
7. Mount the converted brackets to
the back of the assembly with
(6) #8 x 3/4" hex-head screws
supplied.
Continue to kit assembly, p. 5.6
"F"
(Figure C)
Mounting tab(s): identified by a
stamped letter on back of tab
5.2
Dodge Raider/Mitsubishi
Montero 1987-1991
1. Remove the climate control knobs and then
remove the (2) screws above the climate controls.
2. Pop off the cover caps from the sides of the dash
console and remove the (4) exposed screws.
3. Remove (4) screws from the gear shifter plate and
remove the plate.
4. Pull the dash console assembly forward and
disconnect the wiring.
5. Remove (4) screws securing the radio trim bezel to
the console and remove.
6. Remove (4)
screws securing
the factory radio
and disconnect
the wiring.
(Figure A)
Continue on
next page
(Figure A)