Air Intake - EdilKamin NANCY Instalación Uso Y Mantenimiento

SMOKE EXHAUST
NANCY is design to have the smo e exhaust pipe connected to the top, the bac or the right side.
he stove is supplied already set up for a top-connecting smo e exhaust pipe.
CONNECTING THE SMOKE EXHAUST PIPE ON THE TOP
o complete connection simply t a stainless steel chimney ue with an 8 cm diameter (not supplied) on the elbow oint (
which is already mounted on the stove and accessible by opening the right glass door ( g. ).
NO E: An inspection lid for cleaning ( ) is located on the elbow oint ( ).
In this case you must use the pre-cut lid provided separately (C - g. on pg.
uncut lid supplied.
CONNECTING THE SMOKE EXHAUST PIPE ON THE BACK
Loosen the loc ing clamp (F- g. ) of the elbow oint and rotate it by 9 degrees.
Connect the stainless steel chimney ue with an 8 cm diameter, passing it through the pre-cut hole on the lower part of the sheet
metal bac
CONNECTING THE SMOKE EXHAUST PIPE ON THE SIDE
Remove the elbow oint ( - g. )
Remove the cast iron cap on the lower part of the side.
Remove the pre-cut diaphragm on the metal support inside the hole of the cast iron cap
Fit the stainless steel chimney ue with an 8cm diameter on the connecting sleeve (F - g. ) passing it through the cast iron
hole.
In this case the cast iron cap is not longer used.
he elbow ( ) can be used externally to collect condensation.
F G
g.

AIR INTAKE

An air inta e duct connected to the outside with a minimum diameter of 8 cm must be pre-set on the bac of stove in order to
guarantee suf cient air supply to the stove for combustion.
A hole ( - g. 9) is pre-set on the bac of the stove for attaching the duct.
Open the left front door ( g. 8), detach the exible pipe ( ) from its support (S) and push it through the hole ( ) on the bac of
the stove.
Connect the external air inta e duct to the hole until reaching the outdoors.
he external air inta e duct must be less than metre in length, have no bends and must end with a 9
wind guard.
S
T
g. 8
INSTALLATION
G
H
g.
- 28
), removing the diaphragm C , instead of the
g.
g. 9
-
g. )
F
downwards section or a
U
T