Dell Latitude D510 Guía De Referencia Rápida página 22

Ocultar thumbs Ver también para Latitude D510:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

4 Diagnostics can be invoked one of two ways:
Turn on the computer. When the DELL™ logo appears, press <F12> immediately.
a
Select Diagnostics from the boot menu and press <Enter>.
NOTE:
the Microsoft
Press and hold the <Fn> key while powering the system on.
b
NOTE:
Diagnostics from the Drivers and Utilities CD.
The computer runs the Pre-boot System Assessment, a series of initial tests of your system
board, keyboard, hard drive, and display.
During the assessment, answer any questions that appear.
If a failure is detected, the computer stops and beeps. To stop the assessment and restart
the computer, press <n>; to continue to the next test, press <y>; to retest the
component that failed, press <r>.
If failures are detected during the Pre-boot System Assessment, write down the error
code(s) and see "Contacting Dell" in your User's Guide before continuing on to the
Dell Diagnostics.
If the Pre-boot System Assessment completes successfully, you receive the message
Dell Diagnostic Utility Partition. Press any key to continue
5 Press any key to start the Dell Diagnostics from the diagnostics utility partition on your
hard drive.
Starting the Dell Diagnostics From the Drivers and Utilities CD
1 Insert the Drivers and Utilities CD.
2 Shut down and restart the computer.
When the DELL logo appears, press <F12> immediately.
If you wait too long and the Windows logo appears, continue to wait until you see the
Windows desktop. Then shut down your computer and try again.
NOTE:
computer boots according to the devices specified in system setup.
3 When the boot device list appears, highlight CD/DVD/CD-RW Drive and press <Enter>.
4 Select the CD/DVD/CD-RW Drive option from the CD boot menu.
5 Select the Boot from CD-ROM option from the menu that appears.
6 Type
to start the ResourceCD menu.
1
7 Type
to start the Dell Diagnostics.
2
22
Quick Reference Guide
If you wait too long and the operating system logo appears, continue to wait until you see
®
®
Windows
desktop. Then shut down your computer and try again.
If you see a message stating that no diagnostics utility partition has been found, run the Dell
The next steps change the boot sequence for one time only. On the next start-up, the
Booting
.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pp17l

Tabla de contenido