CLAS OH 9030 Manual De Instrucciones página 10

OH 9030
HIGH LIFT AIR HYDRAULIC JACK 30T
- Place the jack so that the load is centred over it and where the
gripping points are indicated by the vehicle manufacturer. DWG. 4
- During lifting and lowering, it is necessary to check there are no
persons or animals under the suspended load or in the vicinity.
- Before lowering the load make certain the handle is in the horizontal
position. DWG. 5
- Never lift loads on sloping, uneven or soft ground. DWG. 6
- If extensions are needed use only those supplied by the manufacturer
with the jack.
Do not use extensions
without the relevant
plate. Never use more
than two extensions.
DWG. 7
- Do not lift the load in a con ned space so as not to run the risk of
getting trapped.
- It is forbidden to use more than one jack simultaneously on the same
load.
- Never tamper with the pressure relief valve that has the guarantee
seal. DWG. 8