Replacing The Vibration Damper - Solo 694 Manual De Instrucciones

Replacing the vibration dampers
CAUTION:
Protective gloves must be put on.
Always replace all five vibration dampers.
5
1
E
- The vibration damper (E/1) is installed next to the
identification plate.
- The vibration damper (E/2) is installed underneath the
guide bar support. The chain catch (a) must be removed.
- The vibration damper (E/5) is installed under the
mounting arm of the tubular handle.
Replacing vibration dampers 1 - 4
4
G
- Put the saw chain on its side and carefully remove the
protective cover (G/4) by means of the universal wrench.
I
- Carefully demount the vibration damper by means of
the universal wrench.
- The vibration damper is mounted in the reverse order.
2
a
STOP
b
F 3
- The vibration damper (F/3) is installed underneath the
oil tank cap.
- The vibration damper (F/4) is installed underneath the
pre-filter. The cover (a) and pre-filter (b) must be
removed.
H
- Use the offset screw driver to loosen the screw inside.
Replacing vibration damper 5
a
J
- Demount the tubular handle (a) (5 screws).
- Use the socket wrench (accessories, not delivered with
the chain saw) to demount the vibration damper
carefully.
- The new vibration damper is mounted in the reverse
order.
4
a
45