Spare Parts; Troubleshooting - Solo 694 Manual De Instrucciones

Spare parts

A reliable and continuous operation as well as the safety of your chain saw depend among others on the quality of the spare
parts used. Use only original SOLO parts.
Only original spare parts and accessories guarantee the highest quality in material, accuracy to size and function and safety.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists to determine
the required spare part numbers, and will be constantly informed about the latest improvements and also about spare part
innovations.
Please, take in mind that in case foreign spare parts are used instead of original SOLO spare parts this will automatically
invalidate the SOLO product guarantee.
Guarantee
SOLO guarantees the highest quality and will therefore reimburse all costs for mending through replacement of damaged
parts as a result of material or production faults, which occur within the guarantee time after purchase.
Please, note that in some countries particular guarantee conditions may exist. In case of any doubts, please, contact your
salesman who is responsible for the guarantee of a product.
We ask for your understanding that we cannot accept any responsibility for damage caused by:
• Disregard of the Owner's Manual.
• Non-performance of the required maintenance and cleaning instructions.
• Wrong carburetor adjustment.
• Normal wear and tear.
• Obvious overload due to permanent excess of the upper limits of capacity.
• Use of guide bars and chains which have not been approved.
• Use of guide bar and chain lengths which have not been approved.
• Use of force, improper use, misuse or accidents.
• Overheating due to dirt on the cylinder ribs and the fan housing.
• Works on the chain saw by unskilled persons or performance of inappropriate repairs.
• Use of unsuitable spare parts or parts which are not original SOLO parts, as far as they have caused the damage.
• Use of unsuitable or old oil.
• Not tightening external screw connections in time.
• Damage related to conditions arising from lease or rent contracts.
Cleaning, servicing and adjustment works are not covered by the guarantee. All repairs covered by the guarantee are to be
performed by a SOLO service center.

Troubleshooting

Malfunction
Chain does not run
Engine does not start or
only with difficulties
Warm start difficulties
Engine starts, but
dies immediately
Insufficient output
No chain lubrication
System
Chain brake Engine runs
Ignition system Ignition spark
No ignition spark
Fuel supply Fuel tank is filled
Compression Inside
system
Outside
Mechanical Starter does not engage
malfunction
Carburetor Fuel tank is filled
Ignition spark
Fuel supply Fuel tank is filled
Several systems Engine is idling
may be involved
simultanously
Oil tank/pump No oil on the chain
Observation
Chain brake actuated.
Malfunction in fuel supply system, com-
pression system, mechanical malfunction.
STOP switch actuated, malfunction or short
circuit in cabling, plug cap, spark plug
or ignition module defective.
Choke in wrong position, carburetor defective,
suction head dirty, fuel line bent or
interrupted.
Cylinder base packing ring defective, radial
shaft packings defective, cylinder or piston rings
defective
Spark plug does not seal.
Spring in starter broken, broken parts
inside the engine.
Wrong carburetor adjustment.
Wrong idling adjustment, suction head or
carburetor dirty.
Tank venting defective, fuel line interrupted,
cable defective, STOP switch defective.
Air filter dirty, wrong carburetor adjustment,
muffler clogged, exhaust channel in cylinder
clogged, spark arrester screen clogged.
Oil tank empty.
Oil guide groove dirty.
Cause
47