Ford FCE6150QV Manual Del Operador página 15

Operating Instructions
When adjusting from a higher to a lower pressure, turn the knob counterclockwise to reach
WARNING!
the desired pressure. Do not exceed operating pressure of the tool or accessory being used.
5. Adjust the regulator to the working pressure of the tool. (never exceed 90 PSI)
Shut down
1. Turn the power switch to the OFF position.
2. Unplug the power cord.
3. Reduce pressure in the tank through the outlet hose. You can also pull the relief valve ring and keep it open in the tank.
Escaping air and moisture can propel debris that may cause eye injury. Wear safety
WARNING!
goggles when opening drain valve.
4. Tip the compressor (if necessary for your model ) so the drain valve is at the bottom of the tank(s).Then open the drain
valve to allow moisture to drain from the tank.
Connecting Air Tools
Maintenance
To avoid personal injury, always shut off and unplug the compressor and relieve all air
WARNING!
pressure from the system before performing any service on the air compressor.
Relieve the air pressure in the system and open the drain valve on the bottom of the tank to drain.
Condensation will accumulate in the tank. To prevent corrosion of the tank from the inside,
WARNING!
this moisture must be drained at the end of every workday. Be sure to wear protective
eyewear.
NOTE!
Quick Connect Coupler
In cold climates, drain the tank after each use to reduce problems with freezing of water
condensation.
OPERATION
Male
Quick
Coupler
Air Hose
Female Quick
Connect Coupler
15
Male Quick
Connect Coupler
Tool