Operation Of The Dispenser; Insert Cartridge; Connect The Dispenser To The Compressed Air Supply; Dispensing The Adhesive - Sulzer DP 200-70 Manual De Instrucciones De Funcionamiento

Dispenser DP
4.

Operation of the dispenser

Insert cartridge

Never insert the cartridge while the dispenser is
connected to the compressed air supply.
Push the cartridge into the cartridge
sleeve as shown in the drawing and
press it down until it clicks into
position. To remove the cartridge
stopper, unscrew the cap nut of the
cartridge.
Fasten the mixer using the cap nut on
the cartridge outlet thread.
If the cartridge is not in the correct position, the trigger (9)
cannot be pressed.

Connect the dispenser to the compressed air supply

Connect the compressed air hose to the compressed air inlet via the
quick-release coupling.
2009-03 (V 2.0)
22905825v3
Sulzer Mixpac AG
8
Dispenser DP

Dispensing the adhesive

Press the trigger (9). Dispensing is started,
and the red dispense volume indicator (4)
moves forward. When the trigger (9) is
released, dispensing stops.
The dispense volume can be controlled by means of the
pressure reducing valve (10).
a) Pull the pressure reduction valve.
b) Adjust the dispense volume by turning the
adjuster in the + or – direction.
c) Press the pressure reduction valve to confirm
the set value.
Do not remove, tamper or manipulate pressure limiting valve and
strictly respect pressure limits.

Removing the cartridge

Release the trigger (9) and press the red
button (13) until the feed plungers have
retracted to the back end-stop. Using the
release button (7), push the cartridge
out of the cartridge retainer and
pull it upwards out of the unit.
Dispose of the cartridge and mixer in conformity with the
manufacturer's specifications.
2009-03 (V 2.0)
22905825v3
Sulzer Mixpac AG
9