Attaching The Anti-Tilt Brackets - Gaggenau RC 462 Instrucciones De Instalación

1. Attaching the anti-tip brackets
ã
WARNING
Risk of injury and damage!
Assure that there are no electrical wires or
plumbing in the area which the screws could
penetrate.
ã
WARNING
Risk of injury! Always wear safety glasses and
other necessary protective devices or apparel
when installing or working with dowels.
Important note:
If a Side-by-Side set up of two appliances is envisaged,
the anti-tip brackets are needed as installation aid.
Connect the appliances before the anti-tip brackets are
fixed to the wall, see "Side-by-Side installation".
Notes:
– Each appliance requires 2 anti-tip brackets.
– The set supplied, contains fastening screws for
various subsurfaces. Select the fastening screws
corresponding to the local conditions.
– If the anti-tip brackets, and therefore the appliance,
cannot be securely attached with the supplied
fastening screws, another suitable method must be
used to attach the appliance securely.
The anti-tip-brackets (a) must overlap a minimum of
1
2 / " (54 mm) over the appliance to secure the
8
appliance.
If this minimum length cannot be observed for structural
conditions it is possible to do this by fastening
a spacer (b) behind the anti-tip angle, e.g. a sufficiently
dimensioned wood board.
The length of the plank should correspond to the width of
the installation niche!
1. Specify the attachment points of the anti-tip-brackets
according to the section on "Dimensions of the
installation niche".
2. Attach the anti-tip-brackets completely.
Be sure screws hold tight.
Important notes for fastening with dowels and screws:
– Not recommended for use in light-weight masonry
material such as cinder block.
– Not recommended for use in new concrete which
has not had time to cure.
– Do not use spiral-flute counterbores (countersinking
tool) to drill the holes.
13