Connecting The Water To The Appliance; Aligning Ice And Water Dispenser - Gaggenau RC 462 Instrucciones De Instalación

Connecting the water to the appliance

Note:
When bending the water line, do not kink it, otherwise
there is a risk of leaks and water damage.
1. Remove the cap from the appliance connection.
2. Bend the water line according to the location of the
connection on the appliance.
3. Push the union nut and seal onto the water line.
4. Push the end of the water line into the appliance
connection and screw on the union nut.
5. Using the open-ended wrench, tighten the union nut.
Do not overturn!
6. Push back the water line into the guard tube as far as
possible.
7. Open the shut-off valve and main water tap.
8. Check the connection on the shut-off valve and on
the appliance for leaks.
9. Close the shut-off valve.

Aligning ice and water dispenser

(only in the case of freezers with ice and water
dispenser)
Note:
Avoid misaligning the door while aligning the ice and
water dispenser!
The ice and water dispenser can be adjusted within the
section of the furniture door. In this way, it is possible to
undertake parallel adjustment to the furniture door in
order to achieve an optimal overall impression.
The gap must be exactly the same all the way round (a)
and
the front surface of the ice and water dispenser must be
aligned exactly parallel with the door front (b).
Aligning ice and water dispenser:
1. Loosen the nuts on the 4 setting screws with
a wrench.
33