Troubleshooting; Environmental Protection - Worx JAWSAW WG307E Manual Original

TROUBLESHOOTInG

If your saw does not operate correctly check the following:
PrOBLEMS
Tool will not start.
Bar/chain overheated.
Chain is loose.
Poor cut quality.
20
Unit runs but does not cut.

EnVIROnMEnTAL PROTECTIOn

This product has been marked with a symbol relating to removing electric and electronic
waste. This means that this product shall not be discarded with household waste but that it
shall be returned to a collection system which conforms to the European Directive 2002/96/
CE. It will then be recycled or dismantled in order to reduce the impact on the environment.
Electric and electronic equipment can be hazardous for the environment and for human health
since they contain hazardous substances.
Limbing and Trimming Electric Chain Saw En
POSSIBLE CAuSES
Fuse blown or breaker
tripped.
Extension cord not plugged
in.
Chain too tight.
Lubrication needed.
Chain tension set incorrectly.
Chain tension set incorrectly.
Chain needs replacement.
Chain installed backwards.
See Fig H and illustration.
POSSIBLE SOLuTION
Check fuse or breaker.
Check to make sure extension
cord is plugged into a
working outlet.
Refer to ADJuSTINg THE
CHAIN TENSION section.
Refer to LuBrICATION
section.
Refer to ADJuSTINg THE
CHAIN TENSION section.
Refer to ADJuSTINg THE
CHAIN TENSION section.
NOTE: Excessive tension
leads to excessive wear and
reduction in life of bar &
chain.
Refer to sections for
CHANgINg THE guIDE
BAr AND CHAIN.
Refer to CHANgINg THE
guIDE BAr AND CHAIN
section.