Troubleshooting Table - Worx WG384E Manual Del Usuario

TROUBLESHOOTING TABLE

The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your service agent. WARNING: Switch off and remove
plug from power source before investigating fault.
Symptom
Chain saw fails to
operate
Chain saw
operates
intermittently
Dry chain
Kickback Brake/Run
Down Brake
Chain/chain bar
over-heats.
Chain saw rips,
vibrates, does not
saw properly.
Cordless Chain Saw
Possible Cause
Low battery charge.
Chain brake not in the proper position.
Over heating
Applying too much pressure while
cutting.
Loose connection.
Internal wiring defective.
On/Off switch defective.
No oil in reservoir.
Vent in oil filler cap clogged.
Oil passage clogged.
Brake does not stop chain
No oil in reservoir.
Vent in oil filler cap clogged.
Oil passage clogged.
Chain is over tensioned.
Dull chain.
Chain tension too loose.
Dull chain.
Chain worn out.
Chain teeth are facing in the wrong
direction.
Remedy
Charge both the battery packs.
Check to see if the chain brake is in
position . Refer to CHAIN BRAKE for
details.
Place the machine in a cool, ventilated
place to cool it down.
Applying relatively less pressure while
cutting.
Contact service agent.
Contact service agent.
Contact service agent.
Refill oil.
Clean cap.
Clean oil passage outlet.
Contact service agent
Refill oil.
Clean cap.
Clean oil passage outlet.
Adjust chain tension.
Sharpen chain or replace.
Adjust chain tension.
Sharpen chain or replace.
Replace chain.
Reassemble with chain in correct
direction.
21
EN