Atag CM4411 Manual De Instrucciones página 119

USE
7
The appliance now grinds the beans and starts dispensing the
coffee into the cup. Once the desired quantity is reached, the
appliance automatically stops dispensing coffee and ejects the
grounds into the special container.
4. After a few seconds the appliance is ready for use again. The
display shows the last selected coffee setting.
5. To turn the appliance off, press the on/off button
Before switching off, the appliance performs an automatic rinse
cycle (a little hot water comes out of the coffee dispenser and is
caught in the drip tray). Take care to avoid scalds.
The lights don't shut off immediately and the cooling span motor
continues to operate as to avoid condensation into the housing.
After about 10 minutes, the appliance switches off completely.
Notes
• If the coffee only comes out in drips or not at all, the knob for setting
the grind level (fi g. 7) must be turned by one position clockwise (see
"Setting the grind level" on page 14). Turn one click at a time until
the coffee is delivered satisfactorily.
• If the coffee comes out too fast and the cream does not meet your
taste, turn the knob by one position anti-clockwise). Make sure that
you do not turn the knob for setting the grind level too far, as coffee
may come out in drips when dispensing 2 cups.
• Tips to make hotter coffee
• After 3 minutes since you last made coffee, you can preheat the
brewing unit by using the menu setting RINSING (see Rinsing
on page 28). Run off the water into the underlying drip tray or
alternatively use this water to fi ll (and then empty) the cup to be
used for the coffee.
• Do not use cups that are too thick, as they will absorb too much
heat.
• You can stop the coffee from dispensing by pressing the "1 cup"
button or "2 cups" button again, or by turning the "cup size" knob
anti-clockwise towards "espresso cup".
.
EN 11