Keyboard Lock; System Time Setting - Gabarron ECOMBI ECO158 Instrucciones De Instalacion Y Uso

3. OPERATING INSTRUCTIONS
CAUTION: DO NOT USE THIS HEATER TO DRY CLOTHES. Do not cover this heater at any time.
CONNECTION/ DISCONNECTION
Power switch. All models are equipped with a switch on the back side panel. It is
used to connect and disconnect ECOMBI.
KEYBOARD:
"Clock" key:
Press the key to display date and
time. Hold it for more than 8
seconds to change values.
KEY "
Press the key to
decrease different
values

KEYBOARD LOCK:

In any operation mode it is possible to lock the keyboard holding the keys
When the keyboard is locked, if any button is pressed, display will show
To unlock the keyboard hold the keys

SYSTEM TIME SETTING

It is necessary to set the system time for the appliance to follow correct programming and to adjust it correctly to the off peak
time periods. Off peak periods have to fit with the ones established in GENERAL SETTINGS part as P1, P2, P3, and P4 (please
go to "General Settings").
To set the system time, hold the key
Then press the key
the week day if weekly programming option is enabled in the GENERAL SETTINGS part:
If it is necessary to set up different values for different days in a week, please go to "General Settings" in this manual and change
P7 setting to "ON" position. Once it is changed come back to "System time setting", set hour, minutes, week's day and validate.
i
ECOMBI does not change automatically from summer time to winter time or vice versa. Depending on
the tariff it may be necessary to change the clock settings to fit these two timings.
-
"
for 8 seconds. The Hour values are changed with the
to save and proceed to change the minutes values. Press
simultaneously again for several seconds.
18
"Operation mode" key:
Press the key to select different
operation modes.
FROST PROTECTION
AUTOMATIC STORAGE HEATER
EMITTER
ECOMBI MANUAL
ECOMBI AUTOMATIC
+
КEY " ":
Press the key to increase
different values
and simultaneously for several seconds.
and the appliance will not respond
and
again to save and proceed to change
.
keys.