Weekly Programming - Gabarron ECOMBI ECO158 Instrucciones De Instalacion Y Uso

4 –ECOMBI MANUAL MODE:
This mode will allow ECOMBI to operate the Storage Heater and the Convector together in a combined way. The Storage
Heater will charge based on the settings of "AUTOMATIC STORAGE HEATER MODE" and if there is any kind of heat loss in
the room and a decrease in the temperature, ECOMBI may operate the "EMITTER MODE "to compensate and balance again the
room temperature.
To select this mode press the key several times until in the display only shows the set up temperature. This is without
any preceding letter "A" or "E" displayed. I.e. .This means that 21,5ºC is the system set up temperature (default).
It is possible to adjust the set up temperature by using the keys and . Temperature value will be changing in
increments of 0,5ºC.
When the convector heating element is working a small red dot will appear at the very right of the display.
i
.
While ECOMBI is charging a small red dot will appear on the left side of the display
Storage Heater and Convector will never work at the same time.
5 –ECOMBI AUTOMATIC MODE, with charge correction:
In this mode ECOMBI operates in a combined way. Storage heater operates during the off peak rate, ECOMBI may operate as
Emitter providing additional heating to the room if necessary.
ALSO THERE WILL BE AN AUTOMATIC CHARGE CORRECTION OF THE STORAGE HEATER FOR THE FOLLOWING
CHARGING PERIODS.
To activate this mode press the key several times until the message is displayed.
А stands for AUTOMATIC mode.
21,5 is the set up temperature in ºC.
When the Emitter is on, a small red dot at the very right of the screen will be displayed.
.
A small red dot next to A will be displayed, when storage heater is on
Operation in this mode is similar to the Ecombi Manual Mode but the % of the storage heater charge is corrected automatically.
If working hours of Emitter is higher than a certain value, storage heater charge will be increased by a certain %. On the other
hand, if Emitter working hours does not exceed this value, storage heater charge level is reduced by the same %.
This behavior adapts the consumption to the real thermal needs, allowing the maximum level of energy savings at the required
comfort required.
The set up temperature is independent of the Storage Heater level of charge. Default setting for charge is 4.0. This value can be
modified by entering into STORAGE HEATER MODE and changing these charging values from 0 to 5.0.

WEEKLY PROGRAMMING

It is possible to select which days ECOMBI will work and which days it will not.
By activating P7 in GENERAL SETTINGS, this option will be enabled.
To enter in weekly settings, hold the key for 8 seconds.
Blinking hours will be displayed. Press the key, then blinking minutes will be displayed. Press the key, then the first
day of the week will blink. Change the week day if necessary with the keys and . Press the key to save.
20