Honeywell MILLER Turbo T-BAK Personal Fall Limiter Manual De Instrucciones Para El Usuario página 9

5.3 Installation in a Lift Application
Honeywell Safety Products recommends mounting all Miller self-retracting lifelines to a suitable
overhead anchorage whenever possible. However, fall protection in lift applications without an
overhead anchorage requires special provisions. The support structure of the lift must meet the
following criteria:
lbs. (22.2kN) per employee attached or be part of a complete personal fall arrest system
standards for construction: OSHA 1926.502(b)(1) and general industry: OSHA 1910.23(e)(1)).
or chamfered (free of burrs and sharp edges) to prohibit damage to the lifeline and enable
the unit to arrest a fall effectively.
pling in the event of a fall (consult the lift manufacturer).
Honeywell recommends the above listed self-retracting
lifelines can be attached at or below the back D-ring of
the user's harness in lift applications under the direction
overhead in this application, the maximum fall arrest forces
may exceed the maximum arresting force listed on the label;
however, the forces will not exceed 1800 lbf (8kN).
The following should be considered when assessing your
application:
the top of the guardrail using self-retracting lifeline
guidelines provided in this instruction manual.
pinched between two surfaces as this may cause excessive lifeline wear and weakness.
assistance when evaluating this installation application.
Us er In stru ctio ns - Engli sh
9
Fig. 6