Taski Swingo 2500 Manual Del Usuario página 67

Notice:
Always calculate and select the lowest lev-
el that is sufficient for good cleaning re-
sults. Thus you will optimize power
consumption and increase the service life
of the machine.
Cleaning start
• Using the direction selector lever,
1
choose your travel direction ([1] for-
1
wards / [2] backwards).
2
2
• If the machine is switched on and the
operator is sitting on the driver seat,
the machine starts moving as soon
as the gas pedal is depressed. If se-
lected, the brush unit is started and
the cleaning solution supply is open.
The speed is controlled by the posi
tion of the gas pedal.
Attention:
When working in heavily furnished or nar-
row zones, the slow approach ON/OFF
button must be pressed. (Display lights up)
The maximum working speed is reduced,
and thus so is the risk of accidents.
• Pressing this button once more will
override this restriction, and the dis-
play disappears.
• If none of the bars in the battery indi-
cator light up, you must drive the
scrubber dryer to the battery charger.
Battery capacity - end of operational readiness
Notice:
The battery level indicator provides infor-
mation on the available operating time.
If none of the bars in the battery indicator light up:
• the brush unit and the suction nozzle are lifted off the floor
after 10 minutes.
• the suction unit is switched off after 10 sec.
• there are 10 more minutes remaining for driving the
machine to the battery charger before it switches off com-
pletely.
Recycling operation (option)
Attention:
The recycling system is not permitted for
high hygiene requirements (e.g. hospitals,
food-processing companies, canteens,
etc.).
Recycling operation is only recommended
for slight to medium soiling.
• Remove the key and actuate the stopping brake.
• Fold the driver seat forwards and open the tank cover.
• Take out the recycling filter from the fresh water tank (Flex-
tank).
• Insert the recycling filter into the recovery tank.
Attention:
Max. permissible water temperature 60°C/
140°F.
Cleaning method
-
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in sev-
eral work steps.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Optionally available wheels can improve
the traction of the machine on the floor.
Please contact your TASKI customer con-
sultant.
Replenishing cleaning solvent
Attention:
The floor surface may be damaged when
working without cleaning solution.
• A signal is sounded if the cleaning
• Switch off the machine (key switch) and actuate the stop-
ping brake.
• Fill water into the fresh water tank (Flextank), see page 63.
Notice:
As soon as the fresh water tank (Flextank)
is filled, the cleaning solution indicator
lights up
• The cleaning solution empty indica-
solution indicator lights up.
tor is reset approx. 5 seconds after
actuation of the gas pedal.
EN
65