Troubleshooting - System Cleaners Voyager 1 Modo De Empleo

MAINTENANCE
Thorough and systematic maintenance will prevent breakdowns.
For maintenance, see the section on this in the separate installation and maintenance instructions.

TROUBLESHOOTING

Fault
Low water inlet pressure
illuminated. Inlet pressure below 1.5
bar / 22 psi
No water or insufficient water at the
nozzle
The unit does not suck up detergent
Poor foam quality
version 8 (08.2017) (F)
Cause
Water supply closed
Water inlet filter clogged
Function selector switch not in the
rinse position
Valve at the end of the hose not
open
Function selector switch is not in
the correct position
Suction filter or chemical restrictor
are blocked by chemical residue
Suction filter is above the fluid level
in the chemical container
Air valve not opened or compressor
not started
Insufficient air supply pressure
(Voyager 1, 2, and 4)
Chemical product is not a foam
product
Chemical restrictor does not match
the chosen chemical type
Suction filter, dosing valve or non-
return valve blocked by chemical
residue
Insufficient water supply to the unit
The compressor's intake filters are
blocked (Voyager 1K, 2K, and 4K)
Non-original foam nozzle fitted
(Voyager)
Remedy
Open for water supply
Clean water inlet filter
Turn the function selector switch to the
desired function
Open the valve on the hose
Turn the function selector switch to the
desired function
Clean the suction filter or chemical
restrictor
Position the suction filter below the fluid
level
Open air valve or start compressor
Increase air supply pressure
Change to a chemical product with foam
booster
Change the chemical restrictor to achieve
the correct dosing percentage
Clean the suction filter, dosing valve and
non-return valve
Make sure that the water supply is as
described in the technical specifications
Clean or replace both intake filters
Replace with original white foam nozzle
6 / 56