City5 Function Table - V2 ELETTRONICA City5 Manual De Instrucciones

DISPLAY DATA DESCRIPTION
dEF no / Si Select the item Si to load the default values
riP.E Light on at rest on the outer side
SPEn - outer lights off
vErd - green light on fixed
roSS - red light on fixed
riP.U Light on at rest on the inner side
SPEn - outer lights off
vErd - green light on fixed
roSS - red light on fixed
AUt.E no / Si Automatic starting up on the outer side
AUt.U no / Si Automatic starting up on the inner side
trAn Si / no Calculation of the transiting vehicles
Po.S.P n.C / n.A Polarity of the sensor of presence (Normally closed n.C / Normally open n.A)
t.PrE 0.0" ÷ 19.9" Length of time necessary to signal the presence
t.PAS 0.0" ÷ 19.9" Time necessary to signal the transit
PrEC Direction with right of way
no - green is given to the first vehicle on the sensor of presence
USC - green is always given to the outgoing vehicle
inGr - green is always given to the incoming vehicle
t.Lro no ÷ 99.5" Time of pre-flashing of the red
t.vEr 0.0" ÷ 99.5" Time of green
t.LvE no ÷ 99.5" Time of flashing of the green
t.roS 0.0" ÷ 99.5" Minimum time of the red
i.SCA Si / no Enabling of the warning light of open gate
C.CEn Mode to send the start control on the control unit of the gate
- a control pulse is given each time recognized the request of starting up of the
Mon
no - the relay is never started up
- the control is kept active during the pre-flashing phase of the red and until given
biSt
i.ALL Enabling of the alarm input
no - the input is disabled (it is no necessary to jumper)
- as soon as the input is active the situation is of emergency; stopped the alarm
biSt
- once recognized the state of alarm, the control unit does not get back to its
Mon
CAP 0 ÷ 9999 Car park capacity
diSP Display state
inPU - the control panel is always displayed
- generally the control panel is displayed, but when transiting a vehicle the
trAn
Cont - the number of vehicles inside the car park is constantly displayed
n.int 0 ÷ 9999 Number of vehicles inside the car park
FinE End of programming mode
no - other changes to be made, don't exit the programming mode
Si - changes finished: end of programming, the control panel is displayed

City5 FUNCTION TABLE

phase in any way
the green light in a way
the control unit gets back to its normal working
normal working: it is necessary to disconnect
number of vehicles inside the car park is displayed for 2 seconds
32
MEMO
DEFAULT
DATA
no
SPEn
SPEn
no
no
Si
n.C
0.5"
0.1"
no
1.0"
15.0"
2.0"
2.0"
Si
Mon
no
0
inPU
0
no