Helo T2 Instrucciones De Instalación Y Manual De Uso página 33

Installation and User's Manual Helo T2
The door switch can be utilized also in supervised institutional and in private use.
Basic mode:
In its basic mode, the control panel's screen is off. As the control panel senses an
object e.g. a hand) less than 50mm from its front surface, the screen activates
automatically. Removal of the object causes the screen to revert to its energy
saving mode, after a designated period. The period to the screen turn-off can be
adjusted to a value between 10 seconds and 5 minutes (see selection: Settings –
General – Period to turn-off).
Turning on the sauna heater:
The sauna heater can be turned on by choosing the START/STOP icon on the front
page (default) and pressing OK. This will cause the sauna heater to raise the
temperature to the one indicated in the control panel memory. Also, the heating will
last the period indicated in the control panel memory. Changing the target
temperature – see below. The sauna heater stays on for the period indicated in
Settings – Maintenance – Settings – Bathing time limit. The sauna heater can be
turned off any time by pressing OK while on the front page.
Pressing "RETURN" while on the front page will bring up the date and time as well
as the sauna room temperature.
Setting the sauna room temperature:
To set the desired sauna room temperature, choose the front page icon that is the
second from the top and press OK. The temperature on the screen is changed by
pressing the up or down arrows. Accept the temperature chosen by pressing OK.
You can set a limit to the allowed temperatures of the sauna room by going to
Settings – Maintenance (code 124) – Settings – Temperature limit
Available values: 60°C–110°C.
Timers:
The sauna heater can be pre-programmed in two different ways: Using the calendar
timer (calendar) or the 24h timer (timer). They are chosen from the menu: Timer –
Calendar or timer. In the calender timer, you can program sauna bathing schedules
for different days of the week.
Calendar timer:
1/6 setting the starting up time
2/6 setting the switching off time
3/6 setting the temperature
4/6 setting the type of function, On = Sauna heater starts with a set target
temperature.
Standby = The sauna heater raises the temperature to a setting that is lower than the
target temperature. The lower standby temperature is set using the menu:
Settings – Sauna – Standby; value 0 – 20°C.. The screen shows an S (for standby).
next to the R (Run). As long as the Standby is active, the standby symbol is shown at
the bottom of the screen.
5/6 setting the desired days of the week
6/6 setting up a repeat, either by week or by month
Finally, the Calendar shows "Function 1", the chosen times and days as well as the
set temperature; also, the calendar icon appears at the bottom of the screen.
The 24h timer:
Setting the time for the sauna heater to turn on. The sauna heater will stay on until
the maximum time set by the control panel is reached. For this period, it will maintain
the temperature set by the control panel.
The sauna heater can be switched off earlier using the OK-key or by pressing the
ON/OFF button if one has been installed.
8
22°c
19:34
2012-03-10
OK
OK
OK
OK
Calendar
Function 1
09:00 - 21:00
45 C
O
MTKTP R
OK
Timers
08:00
Start time
OK