Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. Prior to assembly, set aside and save the hardware
bags packed in the packing. Remove the hanger ball
by loosening the setscrew in the hanger ball until the
ball falls freely down the downrod. Remove the pin
from the downrod, then remove the hanger ball.
Retain the pin and hanger ball for reinstallation in
Step5. (Figure1)
2. The fan comes with black and white wires and
safety cable. Separate and untwist the two wires and
cable and route them through the downrod.
NOTE: You will be using either the 6" downrod
supplied with your fan or an optional downrod
purchased separately.
Loosen the two setscrews in the downro d support.
n I
t s
l l a
d
o
w
n
o r
d
n i
o t
holes in the downrod with the holes in the downrod
support. (Figure 2)
3. Install the clevis pin, hairpin clip and tighten set
screws. The clevis pin and hair pin clip must be
properly installed to prevent the set screws from
working loose. (Figure 3)
WARNING
It is critical that the clevis screw in the downrod support is
properly installed and the setscrews and nuts are securely
tightened. Failure to verify that the clevis screw, nuts, hairpin
clip and setscrews are properly installed could result in the fan
falling.
How to Assemble Your Ceiling Fan
c
o
u
p
e l
. r
A
g i l
n
h t
e
c
e l
v
s i
Hanger
Ball
Downrod
p
n i
Hairpin
Clip
7
Pin
Setscrew
Figure 1
Set Screws
Figure 2
Set Screw
w/Hex Nut
Figure 3
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
