Monogram FZIR360NNRH Instrucciones De Instalación página 26

Design Guide - Stainless Steel Installation
CLEARANCES
22-3/4 "
Minimum
to Wall
130° Door Swing
130°
These units are equipped with a 3-position door stop.
The factory set 115° door swing can be adjusted to
90° or 130° if clearance to adjacent cabinets or walls
is restricted. Order WX14X99 door stop for precise
settings between 90° and 130°.
When Installed into a corner:
Allow 25" (63.5 cm) for a full 130° door swing. Allow
15" (38.0 cm) for pan removal. Allow 4" (10.16 cm) min.
clearance when door swing is adjusted to a 90° opening
for pan access, but pan removal is restricted.
22-3/4"
Min. to
130° Door
Wall
Swing
Clearances for Multiple Single Door Installations
In a side-by-side installation of a left and right door
swing product, a 1" (2.54 cm) clearance between the
units is required. Order ZKBSN720NSS Unification
Kit for an integrated appearance on 2 stainless steel
installed side-by-side. Order ZKBFN720NII Unification
Kit for an integrated appearance on 2 custom panel
models installed side-by-side.
INSTALLATION
ZKBSN720NSS and ZKBFN720NII Unification Kit
• If you are installing two units, side by side, the
installation space must be 71-1/2" (181.61 cm) wide.
NOTE: Additional cutout width may be required when
side panels are used. Add side panel thickness to the
finished cutout to calculate rough-in width.
• The water and electrical locations for each product
must be located as shown.
• A separate 115V, 60Hz., 15 or 20 amp power supply
is recommended for each product.
"
4-9/16 Min. Distance to Wall
90º Door Swing
36-1/2
90°
1"
22-3/4"
Min. to
130° Door
Wall
Swing
2"
"
Clearances for two products installed side-by-side
with the same (left or right) door swing
Allow 2" (5.04 cm) minimum clearance between the
products to prevent door swing interference. Order the
WX14X99 adjustable door stop to reduce the factory set
115° door swing. Allow 15" (38.0 cm) minimum to a wall
to achieve full drawer extension and pan removal.
NOTE: ZKBSN720NSS and ZKBFN720NII Unification
Kit will NOT fit this installation.
Clearances for two products installed side-by-side
with right and left side hinges together
Allow 5" (12.7 cm) minimum between the two products
to prevent one door from striking the other. Use the
WX14X99 adjustable door stop to reduce the factory set
115° door swing and to allow pan removal.
NOTE: ZKBSN720NSS and ZKBFN720NII Unification
Kit will NOT fit this installation.
26
15"
5"
31-1000416 Rev. 0