• CAM DIVIDERS: DIVIDERS CAN BE OPENED AS SEEN
IN PICTURE. SLIDE THE STRAPS THROUGH THE DIVIDERS
UNTIL THE STRAPS AND THE DIVIDERS ARE CORRECTLY
ORIENTATED. ONCE YOU HAVE ACHIEVED CORRECT FIT
AND POSITION CLOSE THE CAM.
• BASIC STRAP DIVIDERS: IF YOU DO NOT HAVE LOW
PROFILE OR CAM STRAP DIVIDER WHICH OPEN YOU CAN
CARRY OUT THE FOLLOWING STEPS BY FEEDING THE
STRAPS THROUGH THE STANDARD DIVIDERS.
• ALL STRAPS: THE DIVIDERS SHOULD BE POSITIONED
BELOW AND SLIGHTLY IN FRONT OF THE EARS. THE
STRAPS SHOULD NOT COVER YOUR EARS.
STRAP LENGTHS SHOULD ALWAYS BE
EVEN STRAP DIVIDERS SIT BELOW AND
SLIGHTLY IN FRONT OF THE EARS.
IN THE EVENT THE STRAPS ARE UNEVEN
LENGTHS BETWEEN THE TWO SIDES
PLEASE NOTE THAT THE STRAPS CAN
BE EVENED OUT BY PULLING THEM TO
EITHER SIDE THROUGH THE MOUNT ON
THE BACK OF THE HELMET.
CHIN STRAP ADJUSTMENT:
WHILE WEARING THE HELMET, THE CHIN STRAPS MUST ALWAYS BE SECURED BY THE CLIP AND PULLED
TIGHT. (N) & (O) SHOW HOW THE CLIP IS OPENED AND CLOSED. (P) SHOWS THE CORRECT POSITION AND FIT
OF THE CHIN STRAP DURING USE. AFTER CORRECTLY SIZING THE CHIN STRAP ENSURE THAT THE LOOSE END
OF THE CHIN STRAP HAS BEEN GUIDED THROUGH AND SECURED BY THE RUBBER O-RING (Q). IF THIS IS NOT
DONE THE CHIN STRAP MAY BECOME LOOSE, COMPROMISING THE FIT AND SAFETY OF THE HELMET.
MAKE SURE THAT THE CHIN STRAP IS WORN CLOSE TO THE TOP OF THE NECK (P). IF THE STRAP IS WORN ON
THE TIP OF THE CHIN, THEN THE PROBABILITY OF THE HELMET COMING OFF IN AN ACCIDENT IS INCREASED.
ENGLISH - 6
SYSTEM 1
SYSTEM 2