Installation; Installation Requirements; Unpacking The Unit - BONAIRE 4500E Manual Del Proprietário

BONAIRE WINDOW COOLER

Installation

Installation

Installation Requirements

Tools

Drill (Power or Cordless)

Adjustable Wrench.

Phillips Head Screw Driver

Drills for drilling pilot holes into window
frame 1/8" (3.2mm) Drill – or appropriate
for size of screw used.

Unpacking The Unit

Warning
When you receive your unit the fan assembly
and the over flow fitting will be partially located
inside the wet section of the product
Fan Assembly
Before installing the product in the window the
telescopic section of the unit
Step 1 Pull the fan assembly out of the unit by
approximately 6" (150mm) until it hits the wet
box wall.
Step 2 Fix the fan assembly into place using the 12
"Hi-Lo thread" hex screws supplied. Ensure the
screws are done up tight so there is no vibration
between the fan housing and the wet box.
Bleed off Fitting (if required)
Step 3 Remove the fastener from the coiled bleed
hose and thread the bleed hose through the
overflow fitting. In some cases the bleed nipple
may require removal to allow the hose to pass
through the fitting. Ensure the bleed nipple is
refitted.
The unit is now ready for installing into your window.
Materials Required (Not supplied)
.
MUST
be fixed in place.

Materials for sealing gap in window

Length of ¼" (6mm) copper or plastic
tubing

33"( 840mm) of suitable spacer material
(if required)

Sillcock Valve - for water line connection
to faucet (see pg. 14)
Step 1
Step 2
Bleed hose
Bleed nipple
Page | 10