11.
INSTALLATION
11.2
STORAGE
The appliance, with or without its packaging, must be carefully stored inside warehouses or in areas protected from the weather
and from direct sunlight, at a temperature of between 0 and +40°C.
11.3
HANDLING
11.4
ENVIRONMENTAL CONDITIONS
ATTENTION
A dry room that can be ventilated is the suitable location for the appliance's installation. There should be a good air
flow around the compressor/condensing unit. Therefore the area around the unit should not be obstructed by boxes
or other objects. Place the equipment away from sources of heat (radiators, heaters of any kind, etc.) and far from
the influence of continuous air movement (caused by fans, air conditioning units, etc.). If it is unavoidable to install
near a heat source, use a suitable insulating plate. Also avoid exposure to direct solar irradiation; all of this causes
the temperature inside the refrigerated compartment to rise with negative consequences on operation and energy
consumption. Do not use the appliance outdoors and do not leave it exposed to rain.
11.5
ELECTRICAL CONNECTION
ATTENTION
Check that the network voltage matches the one displayed on the identification plate of the appliance, and that the
power is adequate. Check on the socket that the power supply voltage provides rated voltage (±10%) when you start
up the compressor. The plug should be directly connected to the electrical socket. It is forbidden to connect the plug
to the socket by means of multiple socket extensions or adaptors. The plant power supply socket must be fitted with
a disconnection device from the mains electricity (dimensioned to the load and in compliance with Standards in
force), which guarantees complete disconnection in category III (3) over-voltage conditions and therefore protects the
circuits against earth faults, overloads and short circuits. Do not route the electricity cable in passageways.
ATTENTION
Remember that earthing is necessary and is a requirement imposed by law.
11.6
CLEANING WATER DRAINAGE PLUMBING CONNECTION
ATTENTION
If the cleaning water needs to be drained outside the dedicated collection tray, a drain pipe can be connected as
indicated below:
Use and maintenance manual
GOURMET ∫ EXPO WINE
+40 °C MAX
0 °C MIN
Handling of the equipment must be performed exclusively by a forklift truck of power adequate to the weight of
the same and operated by qualified personnel: during this operation the equipment must always be positioned
on the dedicated pallet supplied.
Ø 1 inch
Ø 25,4 mm
71
EN
428001127000
2019-12