Briteq BT-METEOR Manual De Instrucciones página 11

ENGLISH
Dimmer Calibration
Due to tolerances in the production process, not all LEDs have exactly the same brightness,
therefore you can use this option to match the Brightness of different machines.
 Use the ▼/▲ buttons until [Calibrat LED] is shown on the display.
 Press the [ENTER] button to start editing.
 Use the ▼/▲ buttons to select a value between "50" (lowest brightness) and "100" (highest brightness).
 Once the desired brightness is found, press the [ENTER] button to confirm.
Note: the default value is 100, a new value cannot be saved to
the USER-defaults.
Offset Adjust men t of different functions
Used to adjust the home position of several functions:
Make sure that the unit is connected to a DMX-controller and set
to 14CH channel mode: set ch6 + ch7 to maximum.
If you're not already in the setup menu, just press the [MODE]
button shortly to enter the setup menu.
 Now press the [ENTER] button for at least 3 seconds to open
the offset menu.
 Use the ▼/▲ buttons to select the function that you want to
adjust, options are:
 [PAN]:
offset PAN movements
 [TILT]:
offset TILT movements
 [COL]:
offset COLOR-wheel
 [GOBO]: offset GOBO-wheel
 [RGOB]: offset of GOBO rotation
 [PRI]:
offset of the prism
 [RPRI]: offset of the prism rotation
 [FOCU]: offset of the FOCUS function.
 Press the [ENTER] button to start editing.
 Use the ▼/▲ buttons to adjust the offset value.
 Press the [ENTER] button to select your setting.
When all offset adjustments are done, press the [MODE] button
for about 2 seconds to store them and to return to running mode.
ELECTRICAL INSTALLATION + ADDRESSING
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Electrical installation for 1 standalone unit:
 Just insert the mains cable. The unit starts working immediately in stand-alone mode.
Remark: if there's no output, please make sure to set the option [No DMX] of the projector to [SOUND]
(audio mode) and sound sensitivity [Sound] to a value over 50 (see previous chapter).
Electrical installation for two or more units in master/slave:
In this mode the units will show a synchronized show, working to the rhythm of the beat.
 Connect 2 to maximum 16 units together using good quality balanced microphone cables. The first unit
in the chain will automatically act as the master, the other units will act automatically as slaves.
 Make sure that all units are connected to the mains.
 Done!
Remark: if there's no output, please make sure to set the option [No DMX] of the projector to [SOUND]
(audio mode) and sound sensitivity [Sound] to a value over 50 (see previous chapter).
BRITEQ
®
9/74
USER MANUAL
BT-METEOR