Briteq BT-METEOR Manual De Instrucciones página 8

ENGLISH
 Once the right mode is shown on the display, press the
[ENTER] button to confirm.
 Press the [MODE] button for about 2 seconds to store the
setting and to return to running mode.
Focus Adjust
Used to help you adjusting the focus of the rotating gobos
while the fixture is used in standalone or master/slave
mode.
You can set the focus of the gobos in different directions.
While working in auto/audio mode the fixture will continuously
try to keep the gobos sharp in the different directions. Please
note that this is not always possible, so the gobos will not
always be perfectly sharp.
 Press the [MODE] button and use the ▼/▲ buttons until the
display shows [Focus].
 Press the [ENTER] button so the unit goes to the "tilt 90°"
position (Adj1).
 Press the [ENTER] button so the unit goes to the "pan 0°"
position (Adj2).
 Press the [ENTER] button so the unit goes to the "pan 90°"
position (Adj3).
 Press the [ENTER] button so the unit goes to the "pan 180°"
position (Adj4).
 Press the [ENTER] button so the unit goes to the "pan 270°"
position (Adj5).
In the Previous 5 steps you are able to adjust the focus with
the ▲/▼ buttons on the unit (the display shows the current
focus status).
 Press the [MODE] button for about 2 seconds to store the
setting and to return to running mode.
Function Delay
On the Function channel (CH11 or CH14) you can select
some special functions, like "blackout during gobo
change" and others. With this option you can select the
delay before a selected function becomes active.
IMPORTANT INFORMATION: the function delay can only be set to zero seconds (no Delay) when you are
using a DMX-controller or DMX-software using presets for the DMX-values of the special functions.
Never use "no Delay" while using a simple DMX-controller with faders to set the functions manually!
 Press the [MODE] button and use the ▼/▲ buttons until [F. Delay] is shown on the display.
 Press the [ENTER] button to start editing.
 Use ▼/▲ button to choose a value between [NO DELAY] / [1sDELAY] / [2s Delay] or [3s Delay]
 Once the right delay is shown on the display, press the [ENTER] button select it.
 Press the [MODE] button for about 2 seconds to store the setting and to return to running mode.
Dimmer Curve
Used to set the dimmer curve of the master dimmer.
 Press the [MODE] button and use the ▼/▲ buttons until [DimCurve] is shown on the display.
 Press the [ENTER] button to start editing.
 Use the ▼/▲ buttons to select one of the available options:
 Once the dimmer curve is shown on the display, press the [ENTER] button to confirm.
 Press the [MODE] button for about 2 seconds to store the setting and to return to running mode.
BRITEQ
®
6/74
USER MANUAL
BT-METEOR