Replacing The Oil Filter (For Plusvac 21 With 40 M 3 /H Pump Only); Replacing Sealing Wire And Teflon Strip - Komet Vacuboy Instrucciones De Operación

Maintenance and Fault Repair
8.7 Replacing the oil filter (for PlusVac 21 with 40 m
Danger!
Electric shock possible!

Pull out the mains power plug before starting work!

Let the pump remove only through a trained person.

First let off the oil. Proceed as described in chapter 8.4.
1
3
40 m /h : PlusVac 21
Operating Instructions- Translation
3
/h pump only)
1 Oil filter

Unscrew the oil filter 1 counter-
clockwise out of the filter
casing.

Bring in the new oil filter and
tighten it.

Fill in the new oil.
8.8

Replacing sealing wire and Teflon strip

Danger!
Electric shock possible!

Pull out the mains power plug before starting work!




Danger!
Electric shock possible!

Separate the protruding end so that there is no contact with the
housing of the vacuum tray (danger of a short-circuit) and there is
no risk of injury.

Pull up the sealing pad away
from the sealing cylinders

Remove the Teflon strip.

Remove the remains of the
sticker using an appropriate
cleaning agent.
1
Undo the screws on the front of the sealing
pad.
Replace the sealing wire.
Screw tight the new sealing wire on one
-
side.
Thread the other end in.
-
- Using a pair of pliers stretch the sealing
wire and screw the end tight.
Replace the Teflon strip.
Fit the sealing pad back into the device.
19 04 249 - 01.01.2012
1
.
Eng - 29 /32