Replacing The Cover Seal And Silicone Rubber - Komet Vacuboy Instrucciones De Operación

Maintenance and Fault Repair
8.9

Replacing the cover seal and silicone rubber

Dichtung ganz in 1, 2
den Nutgrund legen
Vakuum
1
5
Operating Instructions- Translation
Dichtlippe
3
nach außen

When replacing the cover
1
seal make sure that the
seal is lying fully in the base
2
of the groove

Außen-
The seal lip 3 must point
atmosphäre
outwards.

Press the seal firmly into the
base of the groove.
4

To replace the silicone
4
rubber remove the old
silicone rubber from out of
the pressure piece
press the new silicone
rubber in tightly.
.
5
and
19 04 249 - 01.01.2012
Eng - 30 /32