Before Operation; Setting The Clock - Aiwa AV-D50 Manual De Instrucciones

BEFORE OPERATION SETTING THE CLOCK
POWER TAPE MONITOR VOLUME
Function indicators
PHONES FRON+SPEAKERSA, B Function
buttons
To turn the unit on
Press one of the function buttons (TUNER, PHONO,
AUX, CD, VIDEO 1/5.1 CH, VIDEO 2 or VIDEO 3) or
the TAPE MONITOR button.
When pressing the TUNER button, the previously tuned
station is received (Direct Play Function).
The POWER button is also available.
Operation is possible after four seconds, while the VOL
(volume) level or function name is displayed one after the
other and the selected function indicator flashes.
To select the front speaker system
To use speaker system A: Set the FRONT SPEAKERS A button
to sON.
To use speaker system B: Set the FRONT SPEAKERS B button
to ~ON.
To use both speaker systems: Set both the buttons to ~ ON.
Set the button(s) to IOFF to turn off the speaker system(s).
As the front speaker systems A and B are connected in series:
- The sound will be slightly decreased when using both speaker
systems
- No sound can be heard if the FRONT SPEAKERS A and B
buttons are set to -ON when only one speaker system is
connected
Using the headphones
Connect headphones to the PHONES jack with a standard stereo
plug (06.3 mm, 1/4 inch). Be sure to set the FRONT SPEAKERS
A and B buttons to ~OFF. Otherwise sound is output from the
speakers.
m
The 5.1 CH function, Dolby Pro Logic or DSP system is
automatically canceled when the headphones are plugged in.
To
turn the unit off,
press the POWER button.
2,4
When the AC cord is connected for the first time, the clock on
the display flashes.
Set the time as follows while the power is off.
1
2
3
4
5
Press the SET button.
The hour flashes.
Press the DOWNY or UPA button to designate
the hour.
Press the SET button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the DOWNY or
UPA
button to designate
the minute.
Press the SET button to set the minute.
The minute stops flashing on the display and the clock starts
from 00 second.
To correct the current time
Press the POWER button to turn "the unit off. Press the SET
button and carry out steps 1 to 5 above.
To
display the current time
Press
the CLOCK button on the remote control. The clock is
displayed for 4 seconds.
To
switch to the 24-hour standard
Press the POWER button while pressing the UPA or DOWNY
button while the current time is displayed.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes whine
the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase need to be reset.
7
ENGLISH