Section 7 - Right-Hand Release Harness Installation - Holland RK-10855-L Instrucciones De Instalación

Installation Instructions
4. Pound the roll pin into the newly drilled hole flush with
the top of the lug (Figure 16).
NOTE: Before installing the sensors and harness, make
sure the top plate and work areas are free of
chips and burrs.
7. Right-Hand Release
Harness Installation
Cam sensor bracket installation
1. Clean and lubricate the cam plate. Install cam sensor
bracket under lug "B" (Figure 17). Position hole "B"
onto the bottom of the roll pin.
2. Once the cam sensor bracket is attached to the roll
pin, line up hole "C" with the cam bolt hole. Place the
washer over the cam bolt hole, and rotate the cam plate
back into position (Figure 17). Re-install the roller and
second washer. Finally, guide the hex head cap screw
through the washer, roller, cam plate, washer, lug, the
cam sensor bracket, and washer (Figure 18). Screw the
new lock nut onto the hex head cap screw and tighten
securely. Check the cam operation for free movement.
Clean away excess grease.
NOTE: When installing the washers, the rounded edge
of the washers must always face the cam plate.
10
Figure 16
Figure 17
Figure 18
XL-FW10064BM-en-US Rev A · 2011-12-02 · Amendments and errors reserved. © SAF-HOLLAND, Inc.