Section 8 - Kingpin Sensor Bracket Installation - Holland RK-10855-L Instrucciones De Instalación

8. Kingpin Sensor Bracket Installation
1. Mount the kingpin sensor bracket to the fifth wheel
(Figure 19) with the thread-cutting screws. Torque
screws to 12 ft.-lbs. DO NOT overtighten the screws.
DO NOT use air or impact tools.
NOTE: The kingpin sensor bracket mounts in the same
position for both left-hand, right-hand and air
release fifth wheels.
2. Assemble the cable ties and spring clips together before
pressing the clips onto the casting (Figure 20).
3. Route the harness on the fifth wheel as shown (Figure 21).
Use clips and cable ties to fasten the harness to the fifth
wheel ribs in the locations shown (Figure 21).
NOTE: A left-hand release fifth wheel is shown here. For
a right-hand release, the cam sensor bracket and
wiring are mirrored on the opposite side of the
top plate.
4. Re-install the fifth wheel top plate onto the tractor.
XL-FW10064BM-en-US Rev A · 2011-12-02 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Installation Instructions
Figure 19
THREAD-CUTTING
KINGPIN SCREWS
SENSOR
BRACKET
Figure 20
Figure 21
CABLE TIE
11