Section 5 - Left-Hand And Air Release Harness Installation - Holland RK-10855-L Instrucciones De Instalación

Installation Instructions
4. Pound the roll pin into the newly drilled hole flush with
the top of the lug (Figure 10).
NOTE: Before installing the sensors and harness, make
sure the top plate and work areas are free of
chips and burrs.
5. Left-Hand and Air Release
Harness Installation
Cam Sensor Bracket Installation
1. Clean and lubricate the cam plate. Install cam sensor
bracket under lug "A". Position hole "B" onto the bottom
of the roll pin.
2. Once the cam sensor bracket is attached to the roll pin,
line up hole "C" (Figure 11) with the cam bolt hole.
Replace the washer over the cam bolt hole, and rotate
the cam plate back into position (Figure 12). Re-install
the roller and second washer. Finally, guide the hex head
cap screw through the washer, roller, cam plate, washer,
lug, and the cam sensor bracket, add washer. Screw the
new lock nut onto the hex head cap screw and tighten
securely. Check the cam operation for free movement.
Clean away excess grease.
NOTE: When installing the washers, the rounded edge
of the washers must always face the cam plate.
Proceed to "Kingpin Sensor Bracket Installation" on page 11.
8
Figure 10
Figure 11
Figure 12
XL-FW10064BM-en-US Rev A · 2011-12-02 · Amendments and errors reserved. © SAF-HOLLAND, Inc.